English (UK) 
Nederlands 
Deutsch 
Français 
Español 
Português 
Italiano 
Svenska 
Norsk bokmål 
Suomi 
Dansk 
Lietuvių kalba 
Polski 
Čeština 
Ελληνικά 
Eesti 
Română Dosing pumps from the KMS MF series is the ideal solution for low or medium dosing of chemicals. All parameters for operation and set-up are available via a digital keypad and displayed on a backlit LCD screen. The Emec KMS MF metering pump features the following inputs and outputs:
- Standby input
- LEVEL input
- Alarm output (contact)
Flow rate
The flow rate can be determined by the stroke length and the stroke speed. The adjustment knob allows you to set the stroke length between 0% and 100%, only the dosage can be guaranteed within a range of 30% to 100%.
This explanation addresses that of the Emec KMS MF, but can also be used for other electromagnetic models such as the AMS, TMS and VMS (excluding the PRIUS and PRISMA).
Load default values
Do you already own the Emec KMS MF and are you going to use this dosing pump for a different application? Then you may want to reset the pump back to its default values. The moment this happens, all set programme data are deleted. The pump's default data will be reloaded. To do this, follow these steps:
- Unplug the power cord.
- While holding down the 'Up' and 'to the right' buttons, plug in.
- After a few seconds, the display will show 'load default'.
- Then the pump will start up again.
Reset password
The moment you reset the password, the default set password is reloaded (0000).
To do this, follow these steps:
- Unplug the power cord.
- While holding down the 'Up' and 'ESC' buttons, plug in.
- After a few seconds, the display will show 'reset password'.
- Then the pump will start up again.
Change password
The Setup menu is password-protected. The default value to be entered in the Setup menu is 0000 (numeric units only). To change this password, proceed as follows:
- Go to "SET (12) PASSWORD". Then press the E key.
- Use the UP key to change the first digit.
- Use the RIGHT key to move the cursor for the next digit.
- Press the E key to save data and ESC to return to the main menu. Otherwise, use ESC to ignore data and return to the main menu.
Note: Have you lost your password? Read the "Reset password" procedure above.
