Flush functions

Emec KMS MF - Flushing functions

The KMS MF series dosing pumps is the ideal solution for low or medium dosing of chemicals. All parameters for operation and set-up are available via a digital keypad and displayed on a backlit LCD screen. The Emec KMS MF metering pump features the following inputs and outputs: 

• Standby input
• LEVEL input
• Alarm output (contact)

Flow rate

The flow rate can be determined by the stroke length and the stroke speed. The adjustment knob allows you to set the stroke length between 0% and 100%, only the dosage can be guaranteed within a range of 30% to 100%.

This explanation addresses that of the Emec KMS MF, but can also be used for other electromagnetic models such as the AMS, TMS and VMS (excluding the PRIUS and PRISMA).

Flush functions

To proceed, follow these steps:

• Connect all hoses to the pump.
• Open the drain valve by turning the drain valve fully open (counterclockwise).
• Turn on the pump.
• Set the stroke length adjustment knob to 100%. after the pump intro, the pump shows the 'delay'.
• Press any of the buttons to skip the 'delay'. The pump displays the 'strokes' (the actual strokes).
• Press and hold the 'to the right' button to enter flush mode. The pump enters flush mode for 30 seconds.
• When the chemical starts to flow from the degassing tube, close the degassing knob completely (except for self-venting pump heads).
• Stops the flushing procedure.
• If the flushing countdown has not yet ended, press the Escape key.

Now the pump is operational. Proceed to the setup and programming.